click here to enter

Touch sensor

Kingston hackSpace

This breakout board is the simplest way to create a project with a single “momentary” touch sensor. When a capacitive load is detected (e.g. a person touches the sensor-pad area) the red LED lights up and the output pin goes high. You can also solder a wire to the middle pad and create your own capacitive pad if the built-in one isn’t suited to your project. However for additional contacts, I would suggest using copper foil, and then solder a wire that connects from the foil pad to the breakout.

Touch sensor

Arduino Pins







The electronic structure of the touch sensor is very similar to touch board single electrode. Connections are every simple a positive up to 5V to VCC, GND to the negative (Ground) and the middle pin which will transfer a signal to our microcontroller any digital pins.

#define ctsPin 2 // Pin for capactitive touch sensor int ledPin = 13; // Digital pin 13 for the LED void setup() {  Serial.begin(9600);  // Start serial monitor   pinMode(ledPin, OUTPUT);    pinMode(ctsPin, INPUT);} void loop() {  int ctsValue = digitalRead(ctsPin);   // Assigning code responsible for detecting touch  if (ctsValue == HIGH){  // If the sensor detect touch     digitalWrite(ledPin, HIGH);  // Turn the LED ‘ON’    Serial.println(“Touched”);  // Print “Touched” in serial monitor  }  else{ // Otherwise    digitalWrite(ledPin,LOW); // Turn the LED ‘OFF’    Serial.println(“Not touched”); // Print “Not touched” in serial monitor  }   delay(500);}
  • to borrow a touch sensor, click here