click here to enter

Laser Emitter - Kingston hackSpace

Kingston hackSpace

Laser Emitter

A laser emitter as the name of the sensor suggest emits laser, the brightness and strength of the can be controlled using any type of microcontroller. However, laser break beam sensors are usually kind of cumbersome.  They work by detecting an object breaking a laser beam - but you usually have to set up a laser on one end and a sensor on the other.  


...but not this break beam sensor.  It has a light sensor and lens next to the laser to detect the reflected dot when the beam is broken, so it can sense when someone breaks the beam from the starting location. There’s no need for a matching end point sensor!  It forms a good strong laser with a sensing distance of up to 1 meter. 


Laser emit

Arduino Pins










Set up is pretty easy (if you are not sure check it on the diagram below); connect 5VDC to 5V on the Arduino. Ground to the GND and the signal to any of the digital pins on the microcontroller; use a pull-up resistor on the output pin. 

int laserEmit = 13; // Digital Pin 13 for Laser emit 

void setup() {
  pinMode(laserEmit, OUTPUT);

void loop() {
  digitalWrite(laserEmit, HIGH); // Turning the Laser ‘ON’
  delay(1000); // wait for a second
  digitalWrite(laserEmit, LOW); // Turning the Laser ‘OFF’
  delay(1000); // wait for a second

to borrow a laser emitter, click here